Home » Led Adapter LA 12-7
Briechle Elektronik

Led Adapter LA 12-7

In stock
(0)
€0,00 EUR

Share our service:

12 Volt resistor replacement load for the adaptation of light-emitting diode (LED) trailer lamps at vehicles with incandescent lamp monitoring. The failure of a LED unit is indicated and the replacement load is turned off. LED-ADAPT must be mounted on a metal surface.


***CAUTION***
The connection of any bulb on the output is prohibited. The overcurrent protection may cut off not until after several minutes!


▪ Operating voltage: 12V nominal
▪ Input: open cable end
▪ Output: open cable end

Weight: 1.68 kg


  • Simply connect ahead of LED lamps
  • LED failure is indicated
  • The short circuit is indicated
  • Serves all lines with replacement resistors
  • Input cable 3,5m can be connected directly to the plug
Operation voltage: 12V nominal
Output current: 0.8A (Over current protection time delay 1...2000s !)
Connection input: Sheathed cable 8x1mm², bare endings
Connection output: Sheathed cable 8x1mm², bare endings
Load imitation: 2x17 W (direction), 2x4W (rear lamp), 1x34W (stoplight) 1x17W (fog lamp), 1x17W (reversing lamp)
Cable length input: app. 3,5m
Cable length output: app. 1,2m
Temperature range: -40...+75°C
Electrical protection: Overcurrent, overtemperature, reverse polarity
Mechanical protection: entirely sealed
Dimensions: 280 x 70 x 25mm without cable outlet
Mass: app. 1680g
Failure monitor LEDs: 20mA (direction) 3mA (rear lamp) 8mA (stoplight) 8mA (fog lamp) 20mA (reversing lamp)
Mounting rule: cooling plate 8dm² (aluminum sheet 1.5mm thickness) or on chassis frame